sflow receiver To define the sFlow collector, use the sflow receiver Global Configuration mode command. To remove the definition of the collector, use the no form of this command. Syntax sflow receiver index {ipv4-address | ipv6-address | hostname} [port port] [max-datagram-size bytes] no sflow receiver index Parameters index—The index of the receiver. (Range: […]
Management – Web Server
ip https certificate To configure the active certificate for HTTPS, use the ip https certificate Global Configuration mode command. To restore the default configuration, use the no form of this command. Syntax ip https certificate number no ip https certificate Parameters number—Specifies the certificate number. (Range: 1–2) Default Configuration The default certificate […]
Management – Macro
macro name Use the macro name Global Configuration mode command to define a macro. There are two types of macros that can be defined: Global macros define a group of CLI commands that can be run at any time. Smartport macros are associated with Smartport types. For each Smartport macro […]
Management – Line
autobaud To configure the line for automatic baud rate detection (autobaud), use the autobaud command in Line Configuration mode. Use the no form of this command to disable automatic baud rate detection. Syntax autobaud no autobaud Parameters This command has no arguments or keywords. Default Configuration Automatic baud rate detection is […]
Management – User Interface
banner exec To specify and enable a message to be displayed after a successful logon, use the banner exec Global Configuration mode command. This banner is applied automatically on all the user interfaces: console, Telnet and SSH and also on the WEB GUI. To delete the existing EXEC banner, use […]
Management – Clock
clock dhcp timezone To specify that the timezone and the Summer Time (Daylight Saving Time) of the system can be taken from the DHCP Timezone option, use the clock dhcp timezone command in Global Configuration mode. To restore the default configuration, use the no form of this command. Syntax clock dhcp […]
Management – Remote Network Monitoring (RMON)
rmon alarm To configure alarm conditions, use the rmon alarm Global Configuration modecommand. To remove an alarm, use the no form of this command. Syntax rmon alarm index mib-object-id interval rising-threshold falling-threshold rising-event falling-event [type {absolute | delta}] [startup {rising | rising-falling | falling}] [owner name] no rmon alarm index Parameters index—Specifies the […]
Management – Simple Network Management Protocol (SNMP)
snmp-server community To set the community access string (password) that permits access to SNMP commands (v1 and v2), use the snmp-server community Global Configuration mode command. This is used for SNMP commands, such as GETs and SETs. This command configures both SNMP v1 and v2. To remove the specified community […]
Management – ACL
deny (Management) To set permit rules (ACEs) for the management access list (ACL), use the deny Management Access-list Configuration mode command. Syntax deny [interface-id] [service service] deny ip-source {ipv4-address | ipv6-address/ipv6-prefix-length} [mask {mask | prefix-length}] [interface-id] [service service] Parameters interface-id—(Optional) Specifies an interface ID. The interface ID can be one of the following types: […]
Management – Link Layer Discovery Protocol (LLDP)
clear lldp table To clear the neighbors table for all ports or for a specific port, use the clear lldp table command in Privileged EXEC mode. Syntax clear lldp table [interface-id] Parameters interface-id—(Optional) Specifies a port ID. Default Configuration If no interface is specified, the default is to clear the LLDP […]